3D Touch Auto-Bed Leveling Probe Sensor

by ideagen3D


Add ABL to your 3D printer!

​SmartSelf-test : The push pin operate two times in a test when the power is on.
Alarm : The AI will flash the LED indicator if a problem is detected during a self-test or operation.
Wiring defect indicator : Blue and Red LED for indicating wiring defects. ​
High-precision: Precision of only 0.005mm!

3D Touch consists of ATtiny2313A, solenoid, and a push pin.

​Innovative Solenoid: Ultra Power Saving
On idle state, while the push-pin is whether pulled out or retracted, there are no any electric current flowing on solenoid. Standby electric current in the whole device is below average of 15 mA on working state, and stays under 300 mA peak current while probing.

Physical ​Hall Sensor: Free Bed Selection
3D Touch does not use optical, inductive, nor capacitive sensors. Thus, it is compatible with all bed materials.

​Optimized structure: Retain Larger Build Volume
3D Touch is a small, so you don't have to compromise on print volume.

​Easy to Use
3D Touch uses existing RC Servo motor signals, so just plug 3D Touch on the same pins after removing servo motor.

​Control by G-code
​Probing with Push-pin Down(M280 P0S10)

Step 1 : Push-pin Down(M280 P0 S10)
Step 2 : Probing(keep M280 P0 S10)
Step 3 : Push-pin Up(M280 P0 S90) after Zmin triggered

Probing with Touch Switch Mode(M280 P0 S60) ← only Smart V2.1and later
Step 1 : Push-pin Down(M280 P0 S10)
Step 2 : Touch Switch Mode(M280 P0 S60)
Step 2 : Probing(keep M280 P0 S60)
Step 3 : Push-pin Up(M280 P0 S90) after Zmin triggered

Delivery & Pick-up Info

We do NOT have a walk-in physical store to browse, etc. currently.

Courier typically takes 1-8 business days for metro cities around the east coast, a bit more for WA, Tas, and regional areas.

Pick-ups by appointment only, we typically require at least 1 day notice in advance, but sometimes may be ready within minutes/hours. We will e-mail or text you. Typical pick-up times are around 8AM-12Noon, and 10PM-12Midnight, but also available other times by scheduling ahead.